#Code alarm pro 100 code#

Otherwise, the system will re-arm, awaiting the next intrusion attempt. The alarm will resume sounding if an entrance is open. After 30 seconds, the system checks to see if all entrances are closed.

Once the alarm is triggered, the alarm sounds its 125db siren and flashes the vehicle parking lights for 30 seconds. The security system will trigger if one of the following events occurs while it is armed:

Turn the ignition key to the on position.

Enter vehicle (the alarm will begin sounding as soon as the door is opened).

To prevent unauthorized use of the override/programming button, the ignition key is also needed to disarm the system or program transmitters.Дisarming system without the remote control transmitter: The override/programming button is also used to for programming new transmitters to the system. The Override/Programming button is a hidden push button switch that can be used to disarm the security system if your remote control transmitter is lost or stolen. The system will arm after that opening is closed. If the status indicator is on SOLID, indicating your vehicle is in pre-arm mode there is a door hood, trunk or hatch open. Note: If the siren only Chirps once when arming the system check the status Indicator.

The parking lights will flash two (2) times.

If the system is not armed manually by the user, the system will arm automatically one minute after the ignition key is off. Hint: When doing so, remember to arm the system with your remote control. This is useful when unloading your vehicle or anytime when you do not want your system to arm automatically but will want to arm the system later without reentering the vehicle. To prevent your system from arming just one time without engaging valet mode, simply press the disarm button on your remote control transmitter after turning the Ignition key off.

Press DISARM button on remote control transmitter.

Turn the key to the ON or RUN position.

To disengage valet mode and return your system to the normal operating mode: The status indicator to begin blinking a double flash pattern to confirm security system is in valet mode and continue to double flash until the status indicator is disengaged.

Press the ARM button on the remote transmitter.

Valet mode is useful when leaving your vehicle for service or any time you do not what your vehicle to be armed inadvertently. Valet Mode: Valet mode, sometimes referred to as 'keyless mode', when engaged prevents the security system from arming - automatically or via the remote control transmitter - while allowing the convenience features (remote control door lock, unlock and trunk) to remain functional. Atmospheric conditions or interference from other RF-emitting devices can effectively reduce transmitter range. Although at times you may experience range greater than that, there may be occasions when range is less than normal. Press either button on the remote transmitter to turn off the Panic alarm.ДЄbout Transmitter Range: The receiver inside your vehicle security system and the remote control transmitters are designed together to have an average operating range of 50 feet during ideal conditions.

Panic is designed to bring attention to the vehicle and surrounding area, warding off a would-be intruder.

Personal Protection (Panic Alarm): Pressing both buttons together on the remote transmitter activates the Panic feature, sounding the siren and flashing the parking lights. The system is now fully armed.Дisarming the System: To disarm the system, press and release the DISARM button. Once all entrances are secured (and the courtesy light is off), the system will chirp / flash again, and the status Indicator will blink steady. Check to see that all vehicle entrances are closed securely. In pre-arm mode, the status indicator stays on and does not blink. The system has detected that the vehicle courtesy light is on, or that an entrance is not closed securely. Pre-Arm Mode: If the siren chirps and the parking lights flash only once, this indicates that the system is in pre-arm mode.

#Code alarm pro 100 code#

Remote Operation for the Code Alarm PRO100 Security SystemДЄrming the System: To arm the system, exit the vehicle, close all doors, then press and release the ARM button.